Not going into Parking Mode

Is your Dash Cam not going into Parking Mode when you turn off the ignition?

The Dash Cam not entering Parking Mode is caused by either the Dash Cam settings or the wiring itself. The main indication that the Dash Cam is in Parking Mode is the verbal message "Parking Recording will now start" after turning off the ignition.

*If using the Thinkware Hardwiring Kit

If you are using the OBD-II Harness, please click here.

If you are using the iVolt Battery Pack, please click here.

First, ensure you have enabled the Parking Mode Setting.

If the Dash Cam powers off with the ignition the Parking Mode may be disabled.

By default, the Parking Mode is disabled in the Dash Cam Settings. For further information on enabling the Parking Mode Setting, click here.

The Dash Cam is still not entering Parking Mode;

Is the Dash Cam powering off completely (NO LEDS) or is it staying in Continuous Mode?

How to check if the Dash Cam is in Continuous Mode;

You can check if the Dash Cam is in continuous mode by pressing the Manual Record, or WIFi Button. If the Dash Cam makes an audible announcement when a button is pressed, it is still in Continuous Driving Mode.

My Dash Cam powers off with the ignition;

If the Dash Cam is powering off completely the wiring has been Hardwiring has been installed backward.

The Constant Wire which is supposed to have power at all times is losing power when you turn off the ignition, causing the Dash Cam to power off.

You have wired the ACC Wire to a Constant Fuse, and the Constant to an ACC.

Ensure to follow the labelling on the sheath of the wires itself, to determine which cable is Constant and ACC.

My Dash Cam stays powered, and says nothing;

If the Dash Cam stays powered on but does not announce "Parking Recording will now start", the ACC Wire that is supposed to lose power when you turn off the ignition, is not losing power.

The Dash Cam has been wired to 2 Constant Fuses and is unable to detect the change in voltage when you turn off the car. 

Move the ACC Wire to an ACC Fuse, and the Dash Cam will enter Parking Mode. Ensure to follow the labelling on the sheath of the wires itself, to determine which cable is Constant and ACC.

Hardwiring Troubleshooting Tips;

 

 

 

 

Was this article helpful?

0 out of 1 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.